108 - 16001 product specification 11 mar 11 rev a crimping extruded ring terminals ?2011 tyco electronics corporation, a te connectivity ltd. company all rights reserved | indicates change *trademark for latest revision, visit out website at www.te.co m/documents for regional customer service, visit our website at www.te.com 1 of 1 te logo is a trademark. other products, logos, and company names might be t rademarks of their respective owners. loc b 1. scope this specification covers the crimp requirements fo r extruded ring terminals. 2. crimp requirements 2.1. figure 1 illustrates the various features defi ned in the following paragraphs. figure 1 2.2. tab on back end of terminals shall be .020 max imum. 2.3. bellmouth at back of wire barrel shall be .005 to .030. 2.4. wire shall lay flat and must extend through wi re barrel with no more than 3/64 inch maximum overh ang. 2.5. crimp heights and crimp width of the wire barr el and crimp width of the insulation barrel are sho wn in the following table: wire barrel insulation barrel te pn wire size crimp height .002 crimp width crimp width 18 .056 40894 20 .053 .110 f .140 f table 1
|
